Tjernlund VP-2, VP-3 (Discontinued) 8504025 Rev A 01/00  Manual de usuario

Rev. A 01/00 Copyright © 2000, Tjernlund Products, Inc. All rights reserved. P/N 8504025NOTE: The VP-2 and VP-3 Water Heater Vent Packages use a sole

4.IMPORTANT: Wait 4 minutes and push the reset button on linear limit spillage sensing switch.5. Reconnect the blue lead to the normally open terminal

3. Following the water heater manufacturer’s instructions, place the appliance in operation, set thermostat for continuous operation.4. Allow fans and

VP-2 / VP-3 TROUBLESHOOTING GUIDE11Note: For further assistance contact the Tjernlund Products, Inc. Technical Customer Service Department at 1-800-25

12Note: For further assistance contact the Tjernlund Products, Inc. Technical Customer Service Department at 1-800-255-4208, 7:30 - 4:30 CST.NOTE:If t

MAINTENANCE1. Oil motor every six months with 2 drops of S.A.E. #20. The oil ports are located on the top ends of the motor. NOTE: The model VP-3 mot

VENT HOOD MOUNTING TEMPLATE FOR VP-2 & VP-31. Use scissors to detach template. Verify “Vent Hood Installation Clearances” on page 5 are adhered t

Tjernlund Products welcomes your comments and questions. Address all correspondence to: Customer Service, Tjernlund Products Inc., 1601 Ninth Street,

INSTALLER NOTES1. The installer must read and follow these instructions carefully to assure proper installation and operation of the water heater vent

INSTALLATION RESTRICTIONSThe Power Venter shall not be installed on incinerators, condensing type appliances or solid-fuel burning appliances. The Pow

GASPRESSURESWITCHINSTALLATIONRemove the gas pressure switch from the carton also remove the 1/8” compression fitting, the four 1/2” x #10 self tapping

4. Route the linear limit spillage sensing switch cable down the water heater casing locating the end near the solenoid valve. Secure it with the cabl

VENT HOOD INSTALLATION1. Verify that proposed Vent Hood location will conform to “Vent Hood Termination Clearances” on page 5.2. Use scissors to deta

MOUNTING POWER VENTER1. To facilitate installation and reduce vibration, we have included 2 mounting brackets, 2 rubber isolators and 2 rubber grommet

ACTUATING AND SAFETY CONTROL CIRCUIT CONNECTIONS1. Push the black lead from the 6’ 18/2 cable onto the common terminal of the gas pressure switch.2. P